You will need
- Sharp knife, pliers, adapters.
To connect multiple TVs to cable television, you'll need to perform some action. First, you need to purchase a splitter is a device whose purpose is the distribution of signal to multiple outputs. Resembles a tee to outlets, only for a coaxial cable.
Using the tools connected the main cable to the tee and then the cable from the TV to the splitter. All inputs need to pinch with pliers, because it affects the signal quality. After the work done we get a signal on all televisions at each of them, you can watch different channels at the same time.
The second method belongs to connect TV sets to satellite television. It's all much more complicated than the cable signal. Mainly, you will need to determine how you are connected receiver to your TV. At the moment, there are different types of connectors. The most popular are the type of ports VGA, DVI and HDMI. They are all different and connect the VGA cable to the HDMI port directly you will not succeed.
It is possible to connect will need to buy the adapter, because the splitters that you require, there are only VGA and DVI ports. It should be noted that the use of the adapter significantly reduces the quality of transmission of picture and sound.
To carry out this operation of the tools you'll need the same knife and pliers. Also when you connect two or more TVs to one cable satellite TV, all TV sets will show the same channel.
The best way in this case is to order a special receiver, which will output different channels to all connected TVs.
Advice 2: How to connect multiple TVs to one
If you have only one cable, but some TVsit's not a problem. You can resort to a small trick to use a single signal to multiple receivers.
Purchase a special splitter to connect multiple TVs to one cable. Splitter is a kind of tee that splits the coaxial cable. Inspect the splitter. At one end it has only one socket, the other with several. In this one nest directly insert the cable. In the other, insert the prepared wire with the proper connectors to connect them to the TV. These wires you can do yourself or buy in any electronics store.
Purchase an additional splitter, if you use the receiver to access satellite channels. Pay attention to which channel is used to connect the receiver to the TV. To connect multiple TVs to one cable, you will need a splitter with VGA or DVI. They are now very common, therefore, to acquire such a device is not difficult. As in the previous case, plug the source cable into the input socket of the splitter and its outputs run your wires with the appropriate connectors for televisions.
Use adapter if needed. Ports DVI, VGA and HDMI can be connect using a special adapter. You can buy them in the right quantity and computerwide ports. Note that the use of the adapter significantly reduces the signal quality.
Also don't forget that if you connect two TVs to one cable, both TVs will show same channel. You can also use the aforementioned splitters to connect the TV to the connector of the video card your personal computer. As in the previous case, both TVs will accept the same signal.
If you require different TVs to view different channels, do the following. To each of the TVs in one of the connectors connect the coaxial cable of a conventional antenna. At the other end of the cable, which will follow from the splitter. If necessary, you will have the ability to switch between modes of reception channels antenna/receiver.