You will need
- instruction to a gas stove;
- - matches or a special lighter for the stove.
Before you turn on the gas stove, ensure that the conductive tube (gas hose), providing your stove with gas, has no external damage, because of which the gas can flow into the air. Check that the valve on the pipe that brings the gas to your stove, was fully raised. If the pipe mounted ball valve closing off the gas flow, its position must be parallel to the gas pipe.
Determine which relay corresponds to the desired burner. Often, the inclusion of a new gas stove difficult to navigate, because on different plates knobs include can stand for different burners. Note the explanatory scheme of matching handles and burners — normally it is located directly on the housing plate.
If your stove has a electric ignition, read the instructions on using this feature. Depending on the model plate, this system can be implemented in different ways. If the plate housing the electronic ignition to light the gas on the stove, press this button.
It will emit a short electric charge on all four burners. You will only need to turn relay to run the gas in one of the burners. Rotate the relay by adjusting the flame to the desired size.
If a single knob electronic ignition is missing, but the plate is equipped with this feature, when enabled, depress gas relay before cranking. The electrical charge will cause a spark within the burner, to which you are applying gas. Wait until the fire will ignite and adjust the flame size by turning a smooth relay.
If your model of gas cooker has the functions of ignition, bring to the burner lighted match or lighter plates. At the moment when the flame of a match or the spark from the discharge of the lighter is near the edge of the burner, turn relay feed gas. As soon as a fire breaks out, take your hand away from the flame.
In the presence of your oven functions gas control of burners hold relay immediately after the appearance of the flame. System gas control responds to the temperature of the burner. If the temperature has reached a certain value, i.e. the burner has not had time to heat up to the desired extent, the system of gas-control, he regards it as a signal to stop the gas supply to the burner. It is recommended to wait a few seconds before releasing relay-gas.