Advice 1: How to make a machine for living water

Many machines can be done at home with your own hands. For example, you can make the device for the preparation of live and dead water. Living water is considered water, charged with positive charge, dead negative. Drink the living water promotes rejuvenation and cleansing of the body.
You will need
  • Two plates of stainless steel, of a width 5 cm, length 15 cm.
  • A semiconductor diode.
  • Plastic case with detachable cap long 20 cm
  • The plug wire.
  • Two cans of water.
  • Wire.
  • Screws.
Instruction
1
Attach two stainless steel plates to the plastic housing. For this slot in the bottom of two parallel cracks, which can pass plates. Slits should be in opposite ends of the plastic housing. Then insert the plate into the slot and secure them with screws.
2
Place the plastic housing of a semiconductor diode and connect it to the stainless steel plates using wires. Note on the plates from the outside, where the "minus" and where "plus".
3
Make in plastic casing the hole for the wire with the socket. Insert the wire and attach it to the semiconductor diode. Close the housing cover.
4
Fill 2 cans with water. Put them side by side. Dip the apparatus for making a living and dead water in the jars so that each of the electrodes (plates) was in a separate Bank. Turn the device on and leave it on for 10 minutes.
5
Disconnect from the network. Take it out of the cans. Discard "dead" water to drink "live".

Advice 2: How to make a living and dead water himself

About the healing properties of live and dead water have been known since ancient times. This water helps in the treatment of some diseases and improves the condition of the human body as a whole. To receive live and dead water and modern people use self-made apparatus.

Receive live and dead water



Currently, to receive the healing water you do not have to look for some mountain springs and reservoirs. It can be obtained through electrolysis of ordinary tap water at home. From the chemical point of view, living water has alkaline properties and therefore it is perfectly heals wounds. And dead water is a unique disinfectant as it contains acid. When passing through common water, electric current completely changes its structure.

Accordingly, after processing a current of water is divided into two factions. Each has certain medicinal properties. Usually it is recommended to use living and dead water in combination to achieve maximum results.

Camera of live and dead water with their hands



In selling, you can easily find special devices for obtaining activated water. But such a device can be made independently. To do this, take an ordinary glass jar with a lid and clamped on the electrodes using nuts and screws. One of the electrodes is a cathode and the other anode. At the positive electrode will release dead water. This means that at the anode we need to secure the bag made of thick fabric. For such purposes, perfect calico. Importantly, through the tissue normally took the air.

The length of the electrodes for a half-liter banks should not exceed 100 mm. as electrodes can be used in sheet stainless steel. Some even use aluminum electrodes to obtain the charged water. They should be attached to the lid using a special insulating lining.

For the preparation of activated water need to pour the liquid into a cloth bag and strengthen it at the positive electrode. Then it is inserted into a jar of water. You need to consider that the water in the pot should not reach the edges. Usually to cook the living water takes no more than ten minutes. Then the banks pulled out from the electrodes in a separate container and poured the dead water from a special pouch to Pour the water should be very careful not to mix the obtained fractions. To obtain the activated water can be used and design without cloth bag. Then will take two separate containers with separate parts. To provide electrical contact between the two containers can be when you use a cotton harness zamochennogo in gauze.
Note
In any case do not touch the electrodes when the machine is switched on, do not immerse fingers in water during its operation and keep the appliance out of reach of children.
Useful advice
The electrodes can make the coal or charcoal kremnivye. Coal-kremnivye electrodes further enrich the water with silicon.
Search
Is the advice useful?