You will need
- A roll of Fax paper and scissors.
To insert paper, the first step is to open the Fax. To do this, click on the side on the right side of the machine. When this button is pressed, the lid opens automatically. To insert a new paper, you must first remove the remnants of the old that are left inside the unit. It is an empty core, which must be removed and thrown out.
Take the new roll of paper. Since the Fax uses a special thermal paper where the heat-sensitive layer is applied with only one hand, it is very important to correctly insert it in the Fax. In the correct position the coil lies on top of the paper unwinds in the direction of him who holds it. Usually coils are sealed with glue or tape. To avoid getting glue in the Fax machine, before you insert paper in the machine, from the start of the roll to cut off a piece of paper that contains the glue residue. It is approximately 15 cm, i.e., half a standard sheet of A4 paper.
Now you can insert the paper in the Fax. To do this, locate the tiny hole for it above the thermal head (long, round cushion), insert the edge of roll and pull the paper from the Fax machine. Please note that the paper must be properly inserted – it should not SAG or be too strongly stretched.
Close the cover of the Fax by pressing it from two sides until you hear a click. To make sure that everything is done correctly, click on the "Start" button. Fax should display a message on the machine is ready to work. If the message does not appear, the paper is not inserted correctly. Open the Fax again and turn the roll.
Advice 2: How to insert paper
For printing on office and home printers use different paper format. In most cases this is A4 size 210mm*297мм. Its standard density is 80 grams per square meter. Paper this density is suitable for any office equipment.
You will need
- Personal computer, printing device (printer), A4.
Connect the printer. The device must be first connected to a personal computer, and then plug it in. Otherwise, ports of input-output information from the computer and the printer can burn.
Print a stack of A4 paper. Remove required number of sheets.
Put paper in the tray printing the device. Make sure that the sheets are smooth to avoid paper jams during printing.
Slide the side clamps, given that they aren't impacting the paper – this can also cause it to jam.
Open the text document you want to print. Before you print the whole document, click the print settings button to Print a test page. If the test page prints correctly, the paper is installed correctly.
Send a document to print. To do this, click the right mouse button and from the context menu, select Print. You can also open a text document and click the Print button in the text editor.
Not recommended for printing writing paper.
Is the advice useful?
To print multiple copies of a document, you need to set the appropriate parameters in settings of the printer.