Advice 1: How to lubricate a laptop cooler

With prolonged use of the laptop, dust buildup inside the unit can not be avoided. It may not the best way affect the operation of the cooling system, which subsequently will lead to internal overheating and rapid failure. Moreover, one of the main reasons indiscriminately laptops is the pollution of the coolers.
You will need
  • Laptop, special oil cooler, thermoproteaceae pasta
Instruction
1
So, to grease a cooler laptop, you should know the basic principles of analysis laptops. This is important because each model can have its method of Assembly. Read the detailed instructions for your model. Gently loosen the outer screws of the laptop and remove the keyboard panel. Once you get directly to the cooler, disconnect it from the radiator.
2
Before proceeding to the lubricant cooler, you should clean it and the adjacent radiator of the accumulated layer of dust. It is advisable to do a regular vacuum or blow pump. Next, remove the sticker in the Central helical part of the cooler. Below it will be a small hole, closed with a rubber stopper. This hole leads directly to the axis of the motor and its bearing parts.
3
Fill the syringe with some special oil which can be purchased at almost any computer supply store. Taking or pierced with a syringe tube, slowly push the oil inside. In any case, do not inject it – to allow the oil to flow along the axis in the bearing part.
4
Now we have to set the cooler in place. Before that, evenly apply a layer thermoprotei paste on the outer abutting surface of the CPU heatsink. Collect the laptop and immediately give him a little work.

Advice 2: How to lubricate a cooler in a laptop

High-quality cooling system of the mobile computer ensures stable operation of the important elements of the laptop. Timely service allows fans to extend the service life of these devices.
You will need
  • - silicone grease;
  • - Phillips screwdriver;
  • - cotton pads;
  • - metal blade;
  • - tweezers.
Instruction
1
Find out which cooler is not working properly. To do this install Everest, run it and open the menu "Sensor". Find the equipment, the temperature of which exceeds the norm.
2
Turn off the mobile computer. Disconnect the device from AC power. Flip the laptop and remove the battery pack. Now remove the necessary screws from the housing of the mobile computer.
3
Remove some devices that interfere with the normal disassembly of the housing. Most often before opening the case, you need to remove the hard drive, memory modules and the DVD drive.
4
Carefully separate the housing parts from each other. It is better to use a metal spatula. If you don't have this tool, use a screwdriver with a flat tip.
5
Lift one side of the housing and disconnect a few cables. This process should be conducted with tweezers or thin pliers.
6
Remove the lower part of the case and locate the fan. Unplug the ribbon cable of the power supply for this device. Unscrew a few screws and remove the cooler.
7
Siderite the sticker from the fan blades. Remove the plastic cover. With the help of forceps or needle pull the washer and rubber ring. After that, remove the blades from the axis.
8
Wipe with a cotton pad axle and fan blades. Apply a small amount of lubricant on the rotation axis. Install the blades and spin them a few times to evenly distribute grease.
9
Reinstall the retaining ring and gasket. Slip the end cap and attach the cooler to the radiator. Collect mobile computer in reverse order.
10
Turn on the laptop and after 20-30 minutes, run the program Everest. Check the temperature desired items.
Useful advice
It is worth noting that not all laptops require regular intervention for lubricating coolers. Some of it is generally not necessary, but some models are quite often start to make noise and to warm up.
Search
Is the advice useful?