Advice 1: How to disassemble office chair

Sometimes you need to disassemble office chair. Most manufacturers put in a box with a seatm the Assembly instructions, but the disassembly might be difficult in the absence of experience.
You will need
  • Conventional and rubberized hammers, chisel or metal tube, screwdriver
Instruction
1
When disassembling office chair may need conventional and rubberized hammers, chisel or metal tube of circular cross section with a diameter of 30-40 mm.
2
Install a chair near the wall, become the legs on the crossbar facing the chair and grip the armrests. Let the assistant insures you against a possible fall. Pull the seat over the armrests up, swinging it in different directions.
3
If the bed is separated from the gasand turn the star base gas lift down and hold the weight just above the floor, tapping with a hammer around the edge of the gas lift. Use a chisel or a metal tube in the case if the hammer is not reaching the edge. Tapping it gently, trying in any case not to fall on the center of the gas lift – there is a bracket, shock-sensitive.
4
If the gas separated from the crosses, but remained in a swinging mechanism, hold the chair with gas lift down. Raskatayte his blows of a rubber hammer on the top step, reaching out of the swing mechanism. Gas lift will be slightly loose and out.
5
After separation of the gas lift, remove the wheels. Sometimes when removing wheels hands metal pin remains in the cross. Remove it with pliers and return to your seat with a hammer or manually.
6
If you need to replace the swing mechanism, Unscrew the four fixing screws and remove the mechanism.

Advice 2: How to disassemble office chair

Almost all manufacturers of office chairs in the manufacture invest in a box Assembly instructions. However, it is often necessary disassembly of the chair. It should be noted that it is quite difficult.
Instruction
1
For the work necessary to be reserved in advance with a hammer, chisel or metal tube that is circular in cross-section. The diameter of the tube should be about 40 millimeters.
2
First, set up a chair near the wall. Then stand with your feet on patrocle facing the chair and grip the armrests. Best of all, if you will attend the man who can insure at a possible fall. Swing chair in the sides for the armrests and slowly pull it up.
3
In the end, the chair should be separated from the gas lift. In this case, turn the star base gas lift and postukivanie down gently with a hammer around the edge of the gas lift. If this cannot be done with a hammer, use a chisel or metal tube. Remember - it is not recommended to touch the center of the gas lift. There is a mounting bracket, which is very sensitive to shocks.
4
Can also be another outcome of the events, it can separate the gas from the cross. He will remain in the rolling mechanism. Hold the chair so that gas lift was stuck down. Then try to shatter it with a hammer. You need to knock on the top step. Do this carefully so as not to damage the gas lift. He will slowly unravel and come out.
5
After the gas is separated, proceed to pulling the wheels. In rare cases when removing the wheels, and they pull with hands, the metal pin remains in the cross. To get it you can with the help of pliers. Return it to the place with a small hammer or manually. If necessary remove the rolling mechanism, Unscrew the four screws.
6
Before performing the disassembly of the office chair, it is recommended to consult with experts. Also please note - during self-disassembly you may lose the warranty.
Search
Is the advice useful?