Advice 1: How to pump car wheel

Tyres car requires periodic paging to be in the best shape. On the condition of the tires is judged by the pressure inside them, which is determined using a pressure gauge.
Instruction
1
Get a foot pump with fixed gauge, it will help you in any situation to pump up the wheel to the desired level. Or buy an electric pump that connects to the "cigarette lighter" in the cabin of the car. It should also have included a device which will show the pressure in the wheels.
2
Remove the cap, it is always located on the valve. In place of the cap, push the hose that leads from the pump or from the compressor. Do not rush immediately to pump, first look at the pressure gauge. If the pressure is below normal, then you need swap space. Norm is the value 2 to 2.2 atmospheres.
3
Be careful not to exceed, the excess pressure will make the wheel too hard, which reduces the comfort and handling on the road. Sometimes this surplus invalidates the tires – they just burst. When the excess pressure to clear the hose and let the excess air out by pressing on the nipple. At the same time check the pressure in all the other wheels and, if necessary, swap them.
4
If you have a flat wheel on the road, in the Parking lot or in some other place, then after pumping the wheels check if there is a puncture. To do this, raise the vehicle on a Jack and inspect it, scrolling in all directions. If you see entrenched in the tread patterns nail, screw or any other sharp object, then the repair can not be avoided, and pumping will not help. Well, if you have a spare wheel, then it's simple: Jack the car and replace.
5
If you don't have a spare, then try to get to the nearest tire store. To do this, inflate the wheel and, without pulling out a foreign object, move at low speed. If it fails to do so, and the spare wheel you have, then you have to carry out repairs on site with the kit for repair of tubeless tyres.
How to build <b>wheel</b> <strong>vehicle</strong>

Advice 2: How to build a wheel

Support specified by the manufacturer uniform tire pressure of the car helps to save fuel consumption, but also provides the conditions of operating mileage of the tire, guaranteed by the manufacturer. In addition, this is also a very important factor, ensure the safety of driving.
You will need
  • The compressor or pump and the manometer.
Instruction
1
The difference of tire pressure of the wheels creates the conditions for their uneven engagement with the road surface, leading to intensive wear of the tread, and uneven redistribution of loads in each suspension unit, and this leads to the disruption of the balance of stability of the car while driving.
2
Low tyre pressure increases the load on the lateral surface of the wheel, which also leads to uneven distribution of load on the protector with all the ensuing consequences.
3
Increased tire pressure increases the load on the center of the treadmill tread, reducing it to the lateral surface of the wheel. The consequences of too high tyre pressure will also reduce the life of tires and reduces security while driving.
4
In connection with the foregoing, to once every two or three days to check the tire pressure of the wheels in accordance with the manufacturer's recommendations. In case of deviation, the tire pressure is brought back to normal.
5
For the swap wheels, you need to connect the compressor to the cigarette lighter socket, Unscrew the protective cap from the wheel valve, wear of the tip of the pumping hose at the valve and start the compressor. Bringing the tire pressure to normal, the compressor stops, and the pumping hose is detached from the valve wheel. But before the Herz-TS protective cap, be sure to check the tire pressure with a test gauge, and then tighten the cap on the valve.
Note
Plate with the manufacturer's recommended tire pressure, as a rule, is usually placed on the inner surface of the fuel filler flap the fuel tank.
Search
Is the advice useful?