The generic method involves a three-point fastening straps, however it is very complex and more than half of the seats is installed incorrectly. For each age group chairs have their own installation nuances. Seat groups 0+ and 0+1 required a long enough seat belts, so before buying these chairs measure their length, and if it is less than two meters, give up the purchase.
In group 1 a useful feature is the system that donatienne seat belts. So you effortlessly hold the fastener seat. Group 2-3 seats has no internal belts. Here the child is secured in a standard seat belt in the car.
The IsoFix system allows to exclude all the disadvantages when mounting a standard seat. If necessary, install two extender to brackets. Then remove the brackets from the seat and install seat in the vehicle. If you decide to install a child car seat in the front seat, you must disable the airbag, which could injure the child in case of activation.
Carefully align the locks with the braces, and then the maximum move the car seat to the back seat in the car. After hearing a distinctive click check, changed the color of the indicator mount from red to green that is a signal that the locks are correctly connected to the brackets.
Then install the anchor strap which further secures the back of the chair. Adjust leg-emphasis so that it fits snugly against the floor of the car. Well as of correct adjustment can be judged by the indicator: it will change to a red color to green. Remember that for security purposes, chairs are put on a course of movement of the vehicle, and cradles a baby against the move.
Advice 2: How to properly install a car seat
Car seat for a child in the car is not only a fashion accessory or a way to control the child in the car. According to crash tests car seat allows to provide the child with maximum safety during the movement, the sudden jolts, and in the event of an accident.
Classification of seats
Device car child seat differs depending on its purpose, that is given to children of what age they developed.
The chair of the category "0" (referred to as seats-carryings, autorului) is designed for children from birth and assume a horizontal (or nearly horizontal) position of the child. They are installed in the rear seat of the car.
Couch in the "0+" usually have two positions: for sitting and for sleeping. These chairs are set against the motion of the vehicle on the rear or front seat and has two types of mounts: universal safety belt is fitted to the cars and five-point internal harness (over both shoulders, waist and between the legs of the baby).
Chairs category "1" is set on a course of movement, they are equipped with internal seat belts, universal seat belt fixed seat.
Seats "2", "3" have no special belts: the seat and the child are recorded by the vehicle safety belt.
Basic rules for installation of children's car seats
According to statistics, six out of ten seats attached incorrectly, which means that they not only protect the child in case of an accident, but they can cause injury, even death. Installing the car seat in the car carefully read the instructions attached to the seat, and always follow it when installing car seats, free from compromise due to the fact that the baby is fussy or sleeping.
Please note that in chairs category "0", "0+" baby's head must fully lie on the back seat, not to look out of that. This is necessary due to the fact that the baby's head is quite large and the cervical vertebrae are more fragile, in the event of an accident, and even sudden braking there is a risk of injury to the cervical spine. For this reason, these seats must always be installed against the direction of traffic.
Note that internal security straps in chairs, "0", "0+" should be placed just below, and in chairs to "1" slightly above the shoulder of the baby. If the child is sitting in a chair, "2", "3", make sure that the car seat belt went across the middle of the shoulder of the child, as in the location above, this can lead to suffocation, while slipping below the child can simply slip out.
In any case, do not fix a car seat backrest of the front seat.
Remember that the safest place to install car seat is the seat immediately behind the driver's seat, but control of the baby to the driver in this case, it is uncomfortable. So install the right seat or center rear seat.
This provides a more reliable fastening of a seat when a side impact blow is better campfires. But in this case the ISOFIX is not a mount as such, but merely provides additional convenience and safety. On the contrary, are easy to attach car seat on the back seats, which is a so-called "sofa". More comfortable rear seat, consisting of three separate full size seats.
Fastening of child safety seats is the basis for the safe placement of a child in the car. What would be the perfect chair was not, if it is not properly secured, then it not only can not protect Your child, but may even cause additional injuries in case of an accident or just emergency braking. Mount the baby seats in the car may be the standard straps of the car by Isofix or special locks on an additional platform.