Choose location to install a satellite dish on the grounds that all satellites are in the southern direction, if you live in the Northern hemisphere, and North if your South hemisphere. Any obstacle on the line "satellite antenna", even the leaves of the trees, will make reception impossible.
Check whether your chosen place is a good compromise between ease of installation (service) and security from unwanted external influences on the plate.
Assemble the antenna according to instructions supplied with it.
Install it at the selected location (to screw on the brackets, hang the antenna) so that was adjustable.
Prepare the cable by installing high frequency F-connector when the antenna was removed from TV.
Connect the Converter and the receiver using a cable. Connect the receiver to the TV.
Bring electricity to the installation site of the antenna.
Connect the receiver and TV are powered up.
Install the antenna in that direction and at that angle, and neighbors.
Hit a couple of times the "i" button, if you bought a pre-configured receiver. If not, enter the menu and follow the instructions until you see on the TV screen, the tuning dial quality. If the signal is detected, go to step 13.
Slightly change the vertical angle of inclination of the plates. If the signal is not detected, try again or go to step 12.
Apply the required antenna tilt, after using the program Satellite Antenna Alignment is used to calculate the angle of installation, specifying the coordinates using GPS.
Slowly rotate the antenna in the horizontal plane, achieve the maximum level of the signal.
Tighten all mounting bolts. Click OK in the settings menu.
The name of the channels make sure you have got a satellite.
In order to mount a satellite dish, you need to carry out work that may be dangerous to life, since directly related to the electricity and run at altitude.