Advice 1: How to adjust Cabinet door

The most common reason that the door of your closet sagged and ceased to function properly, is a weakening of the hinges. To adjust Cabinet doors it is possible yourself using a minimal set of tools.
You will need
  • - Phillips screwdriver;
  • glue;
  • - matches;
  • door leveler;
  • - hammer;
  • pencil;
  • - the range;
  • - the drill.
Instruction
1
Open the Cabinet and inspect the hinges. As a rule, doors wardrobes and kitchen cabinets are fixed on the Cup hinges. One side of the loop is set in a special hole on the inside of the door, and the second is fixed on the sidewall, on the inner side. This construction allows to correct the distortions and to adjust the closing mechanism.
2
Check the tightness of the four mounting screws, which are fixed to the Cabinet door. If they are loose, tighten them. To do this, take a match and make them wooden plugs of appropriate size. Remove the screws. Gently RUB the cork with glue and insert in the mounting hole. Install and tighten the bolts.
3
To adjust the distance between the closed closet door and the front edge of its wall can by loosening the screw located on the far side of the loop, and gently pull the door forward. You must then tighten the mounting bolt.
4
If the hinges of your Cabinet are worn out and adjust the doors with their help it could not - replace the mechanism for a new, slightly changing the place of installation. To do this, remove the old hinge by loosening fasteners with a screwdriver. Mark with a ruler and pencil new position of the hinge mechanism on the doors and the sidewalls of the Cabinet. Drill the mounting holes and secure the new hinge with screws. Check your installation. If necessary, zashpaklyuyte old mounting holes.
5
Align the hollow paneled door kitchen Cabinet with door leveler. Fix the equalizer on the door so that it is located on its diagonal, from the upper loops to the lower angle. Tighten the equalizer to return the door to its rectangular shape. Note that this tightening should be performed slowly to ensure that all the shifts in binding occurred uniformly.

Strengthen the connection of the door by installing corner ties from the inside or scoring the wooden spikes.

Advice 2: How to adjust Cabinet door-coupe

Wardrobe is often confused with a pull–down module or built-in wardrobe. This is wrong; the main difference and perhaps the main plus of the wardrobe, that its doors ride on rollers on rail. What could be simpler: push – open, push – closed. Sometimes easy and soft movements of the door must be adjusted.
You will need
  • - Allen key 4 mm;
  • pencil;
  • - flat-head screwdriver.
Instruction
1
Dip one of the corners of the door, for example, the left. Use the hex key counter-clockwise twist of the bottom screw. Your Cabinet door will fall. Adjust the door so that the gap in the position of the left roller was 4-5 mm.
2
Adjust the right roller in the same way as the left. Lift the corner of the doorby twisting it clockwise with the key adjusting screw. Get the perfect position of a door of your closet-compartment, for this, adjust the position of the canvas so that the gap was 4-5 mm and the door of the compartment to the sidewall fit very tightly.
3
Adjust the stoppers. To do this, push the door of your wardrobe-a compartment to the side panel and put at risk the pencil in the area where the center roller is on the bottom rail. The door slide to the side. Slide the stopper with the flat screwdriver so that the marked line coincides the center. Check the door: close it and see if the door hit the stopper wheel, and clung to the sidewall, everything was done correctly.
4
If when checking the door of the wardrobe-compartment formed with a side clearance, slide closer to the sidewall of the stopper. If not, the stopper does not reach, then move, but just a little bit, stopper back.
Note
Follow up, keep in mind that the surface is uneven. So, you may have to set the wheels differently. Also, sometimes perfectly adjust the door does not work. Typically, adjustment screws do not withstand great stress and, if you will very much push on them, they will become worthless. Do not adjust the time, otherwise the wheels will deteriorate.
Is the advice useful?
If you have the desire to achieve a smooth closing, then use the closer. Closers designed for doors weighing from 20 up to 60 pounds. Distinguish the right (R) and left (L), respectively, for right and left doors.
Note
Doors for cabinets Quasar own making are of aluminum frame, light weight, reliable locks and modern look. QUASAR mirror doors for built-in wardrobes. Built-in wardrobe with sliding (bottom) and double (mezzanine) doors QUASAR. Flush handle for Cabinet doors.
Useful advice
These doors comfort contribute to the preservation of woolen and fur clothes from moths, as the air in the cabinets with exterior louvered doors dry and unfavourable for insects. The door in the bathroom and the bathroom. Cabinet doors can transform your old furniture beyond recognition.
Search
Is the advice useful?