Advice 1: How to reset ink cartridge

When filling cartridges inkjet printers sometimes you need to reset their values, otherwise the print head cartridge will not move from his seat. To reset the chip inside the cartridge uses a special device — a programmer.
You will need
  • - the printer cartridge;
  • - the programmer.
Instruction
1
If you encounter such a problem, it is necessary that you understand what you will do. Inside some cartridges have chips that count the amount paint or tiles, which is consumed during printing. Roughly speaking, the chip acts as a timer, at the expiration of the required values on its dial, the printing is automatically locked.
2
Typically, the chips of the cartridges that came with the printer, it is difficult to reset. You need to buy the same original cartridge for which it would be possible to reset the values. To perform this operation, use a hardware programmer. In appearance this device has a small size, about a couple of matchboxes or slightly more (depends on the model). On one side are the contacts and on the other lights, sometimes there are still some buttons.
3
For example, for cartridges from Epson printers, the order of actions is as follows. Open the printer cover and remove the cartridge by pressing a special button, which should light in red, since the paint came to an end.
4
Take the cartridge (black or color) in one hand and in the other hand should be a programmer. Align the terminals of the device reset with the cartridge contacts, then press the appropriate button. After turning signal indicator, disconnect both devices.
5
The same procedure repeat with the other cartridges, then insert them back into the tray of the print carriage. Close the lid and press the button again, signaling the small amount of ink.
6
Repeat print the open document, check the rate of ink through the printer driver. If the ink remained in the same position as before drop, repeat the process again.

Advice 2: How to reset inkjet printer HP

Reset chip HP printer is required for subsequent use of the cartridges. This is due to the fact that they refilled manually can cause further printing device can not accept the cartridges correctly.
You will need
  • - ink cartridge;
  • - the layout of the chipsets on the cartridges;
  • - Scotch.
Instruction
1
For starters, get an ink that is right for your printer model. Do not skimp on this - because their quality depends on the durability of the equipment. The exact name of your printer, see the instructions for this device.
2
Download from the Internet the layout of the chipsets on the cartridges. This can be done from official website of HP company. It should conform to your model of inkjet printer. Otherwise, these steps may not help. Also, check whether it can be used for zeroing. If Yes, then follow the instructions.
3
Pursuant to the scheme, remove your cartridge from the printer and place it with the contacts facing up. The print head should be forwarded to you. The figure will indicate the sequence chipsets. To begin the process seal with tape first. Then insert the cartridge into the slot and turn on the printer. On the screen you will see a message stating that it cannot be used for printing. Ignore the information and print a test page.
4
Again pull the cartridge and check the next contact, while two of them must be glued. Perform the same operation - insert the ink cartridge into the printer and perform the printing of the document. After that, remove it.
5
Next, peel off the adhesive tape from the first contact. Re-install in the compartment cartridge, and print a proof copy. Take it out, and release the second pin from the tape. Periodically wipe them with alcohol wipes for better contact with the phases.
6
In the process of the steps above, the chipsets are set to zero. When you install the cartridge back software inkjet printer starts to recognize it as full. The following steps must be performed each time refilling the cartridges.
Search
Is the advice useful?