You will need
- - the perforator;
- - screws;
- - screwdriver;
- - hacksaw;
- - the door leaf.
The installation of wardrobe doors-coupe start only when the box and inside filling this Cabinet is already fully assembled. First of all, as accurately as possible measure the width of the upper opening of the wardrobe-compartment , and adjust the result, subtracting from this figure to 2 mm.
Then transfer this value to the upper guide and cut this subassembly right angle. Remember: to cut the upper guide should be from the rear (this way you will minimize the possibility of damage to the front side of the subassembly).
On the top profile every 30 to 50 cm mark and drill the holes (these will be attached to the screws). Due to the fact that you need to drill through the hole (and the rear and front of the top rail), to perform this operation, take with all responsibility: there is a marriage and mistakes are not acceptable.
Lean the top profile to the cupboard and make sure that the holes are drilled correctly. If when marking and drilling you were not a mistake, each upper guide wall will separate only a millimeter distance. Making sure that everything is performed correctly, attach the top profile to the wardrobe-a compartment on the screws.
Measure the distance of the doorway of a wardrobe-compartment in the lower part and subtract from the value of 1 mm. Then transfer this value to the lower profile and cut this guide at a right angle.
Attach the bottom profile to its rightful place, but do not attach it.
Assemble the doors of the wardrobe-coupe, setting a first upper guide wheels at the top, and then lower – lower profile. Then use the adjustment screws to adjust the door and tighten the lower guide.
Prior to attaching the bottom panel, align the maximum horizontal and vertical surfaces.
To provide additional adjoining leaf, using stoppers. These positioners are mounted so that in closed position of the door of the closet firmly joined to the wall.