- The car should stall Parking brake, including the insertion of first gear or reverse gear. If a wheel happens on the road, be sure to take care not to create an emergency and not to disturb other road users. In this case, you need to install the car special sign emergency stop and activate the emergency lights.
- Before you remove the wheel, lock the wheel with the opposite side of the car wheel stops; if the special stops at hand was not, you can use a conventional bricks or stones that are found near the roadway.
- If you have to deal with wheels with steel stamped discs, pre-remove the decorative cover (this operation can be easily accomplished by using the ordinary screwdriver, inserting it between the rim and cap).
- All nuts of fastening of a wheel it is necessary to weaken (but only one turn.) After that the car should be raised with the Jack to install the Jack should not those parts of the side amplifier, which is specially designed for this purpose). If you have to remove the wheel in the middle of the road with very soft soil under the Jack it is necessary to enclose a small piece of Board to ensure the stability of the structure.
- After was involved in the Jack, wheel nut, wheel can Unscrew completely. The wheel can be removed without much effort, it is usually sufficient just to pull it up for yourself.
- After the wheel was replaced, do not forget to carefully tighten the nut and check the quality of their attachment repeatedly for 10-12 kilometers.
Advice 2: How to remove the wheel on the motorcycle
People who do not have enough adrenaline, buy a motorcycle. These two-wheeled monsters easily go round almost all the traffic jams. The fuel consumption of the motorcycle is much less than the car, which makes it more attractive. However, the bike also require maintenance. For example, sooner or later will have to change the wheels of your motorcycle. How to do it yourself, without the services?
You will need
- A set of tools, stand for Moto, rag, and polishing machine.
First, find a place where you change the wheel. best for this purpose, suitable garage, because in it you will be protected from the weather, and the place will be enough. Turn off the ignition of the motorcycle. Now you need to hang the front wheel so that it was in the air. Distance from floor to wheel should be about 20 centimeters. Put under the load bearing part of the construction of some object such as a wooden block. Carefully secure the motorcycle in such a position that the dismantling of the wheels he fell. Much easier and more convenient to perform all the manipulations together.
Then find the nut tightening the left bolt. Slide it off the ground, and Unscrew several turns. Pull off the nut have a smooth strong movement to inadvertently damage the screw thread. If the nut first went easily and then start a tight scroll, then stop, make a few turns in reverse order and proceed to unleash it. Once this, remove the front wheel axle., where is the thread on the left side.
Now gently pull the front axle. It is necessary to have a second person hold the wheel in the same position. Then, remove the wheel and protective cover. The wheel itself should now easily removed together with the brake cover. Already removed wheels must be removed and the brake cover. The process of removing the rear wheels is almost the same. After removing the protective cap can move that wheel with the brake pads and carefully pull it from the plug frame. When you do this, ensure that no parts are damaged. The plug will need to be cleaned with a rag and inspect for deep scratches and torn. If there are, then you need to Polish the surface of the plug.